Vox AC4 tone stack

Tone stacks and tone controls from amps and pedals, from their schematics, with the stage that drives each one and what it feeds. Turn the knobs and watch the curve. Pin a setting to compare, change any part, and listen through a speaker. Pickups and guitar knobs are on the Guitars page.

The Tone control of the Vox AC4, with every part as on the bench.

Swipe sideways for the whole drawing. Tap a part to change it. The source drives the end marked in, and the load hangs on the end marked out.

At this setting

Frequency response

0 dB is the source’s voltage with nothing hooked to it, so the curve shows what the stack cuts. A tube source changes the curve only through its output resistance, not its gain.

Pin this curve keeps what the graph shows, up to three pins in their own colors. Pins stay when you switch stacks, so you can lay a Marshall treble sweep over a Vox one. In a sweep, the lightest line is the knob at 0 and the darkest is 10.

Listen

You hear a picked string through a guitar on full, with 15 feet of cable. Play without it leaves the stack out.

Source and load

Driven by

Driving

The knobs

Tone
Tone, 1 MΩ log, a variable resistor from C11 to ground. Counterclockwise its resistance falls and C11 cuts more treble. Clockwise is brighter, assumed, since the drawing doesn’t mark it.

Parts

C11
1 nF, The tone cap, from the top of the volume to the Tone pot.
Tone
1 MΩ, Tone, 1 MΩ log, a variable resistor from C11 to ground. Counterclockwise its resistance falls and C11 cuts more treble. Clockwise is brighter, assumed, since the drawing doesn’t mark it.

Source and load

Source: 180 kΩ, the output resistance of the stage before it on the bench at 1 kHz. Load: none. The network connects to a single node, so the source by itself sets what it does.

Values, wiring and drawing are taken from the Vox AC4 on the bench, so the two always match.

How a tone stack works

The mid scoop Where a stack passes the bass and the treble by different paths, there’s a stretch in between where neither path passes much. That dip in the mids is the scoop. Its depth and center move with the knobs. In the FMV stack the slope resistor and treble cap set where it sits, and the mid knob fills it in. A plain low-pass or high-pass filter has no scoop.

Warnings The summary above the graph turns red if the stack can’t be solved as set, usually from a part at zero or a shorted pot track.